Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Toyota Avalon XLSFACTORY OEM SERVICE PROCEDURE
Service Data
SERVICE DATA SPECIFICATION CHART
| Starter assembly | - | |
| Specified current | 90 A or less at 11.5 V | |
| Starter relay | - | |
| Specified condition | 3 - 5 | 10 kΩ or higher |
| 3 - 5 | Below 1 Ω (when battery voltage is applied to terminals 1 and 2) | |
| Engine switch | - | |
| Specified condition | 7 - 5 | 10 kΩ or higher (Engine switch OFF) |
| 2 - 5 | 10 kΩ or higher (Engine switch OFF) | |
| 7 - 5 | Below 1 Ω (Engine switch ON) | |
| 2 - 5 | Below 1 Ω (Engine switch ON) | |
| Ignition or starter switch assembly | - | |
| Specified condition | - | 10 kΩ or higher (Switch condition LOCK) |
| 1 - 3 | Below 1 Ω (Switch condition ACC) | |
| 1 - 2 | Below 1 Ω (Switch condition ON) | |
| 1 - 3 | Below 1 Ω (Switch condition ON) | |
| 5 - 6 | Below 1 Ω (Switch condition ON) | |
| 1 - 2 | Below 1 Ω (Switch condition START) | |
| 4 - 5 | Below 1 Ω (Switch condition START) | |
| 5 - 6 | Below 1 Ω (Switch condition START) | |
| Starter assembly | - | |
| Starter armature assembly | - | |
| Commutator depth | Standard | 3.1 mm (0.122 in.) |
| Maximum | 3.8 mm (0.150 in.) | |
| Resistance (between the segments) | Standard | below 1 Ω |
| Resistance (between the commutator and armature coil core) | Standard | 10 kΩ or higher |
| Starter commutator end frame assembly | - | |
| Brush length | Standard | 9.0 mm (0.354 in.) |
| Maximum | 4.0 mm (0.158 in.) | |
| Resistance | Standard | 10 kΩ or higher |
| Repair starter armature assembly | - | |
| Snap ring length | Maximum | 5.0 mm (0.197 in.) |
| Service starter kit | - | |
| Resistance (between terminals 50 and C) | Standard | below 1 Ω |
| Resistance (between terminals 50 and switch body) | Standard | below 2 Ω |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
