2007 Toyota Yaris S, AutomaticFACTORY OEM SERVICE PROCEDURE

On-Vehicle Inspection

  1. INSPECT ACCELERATOR PEDAL ASSEMBLY 
    1. Connect an intelligent tester to the DLC3.
    2. Turn the ignition switch ON and turn the tester ON.
    3. Select the following menu items: Powertrain / Engine and ECT / Data List / Accelerator Pedal Position No. 1 and Accelerator Pedal Position No. 2.
    4. While the accelerator pedal is depressed or released, check that the values of accelerator pedal position No. 1 and accelerator pedal position No. 2 are within the specifications.

      Accelerator Pedal Position No. 1 Standard Voltage 

      VOLTAGE SPECIFIED CONDITION

      Condition Specified Condition
      Accelerator pedal released 0.5 to 1.1 V
      Accelerator pedal depressed 2.6 to 4.5 V

      Accelerator Pedal Position No. 2 Standard Voltage 

      VOLTAGE SPECIFIED CONDITION

      Condition Specified Condition
      Accelerator pedal released 1.2 to 2.0 V
      Accelerator pedal depressed 3.4 to 5.0 V

      HINT:

      If the results are not as specified, check the accelerator pedal, wire harness or ECM.

      Fig 1: Connecting Intelligent Tester To DLC3
      G04828466Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.