Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Toyota Sienna CEFACTORY OEM SERVICE PROCEDURE
Torque Specifications
TORQUE SPECIFICATIONS REFERENCE CHART
| Part Tightened | N*m | kgf*cm | ft.*lbf | |
|---|---|---|---|---|
| Wheel nut | 103 | 1, 050 | 76 | |
| Brake actuator x Brake actuator bracket | w/o VSC | 5.4 | 55 | 48 in.*lbf |
| Brake actuator x Brake actuator bracket | w/VSC | 5.4 | 55 | 48 in.*lbf |
| Brake actuator bracket x Body | 20 | 199 | 14 | |
| Front speed sensor wire harness clamp x Shock absorber | 19 | 192 | 14 | |
| Front speed sensor x Steering knuckle | 8.0 | 82 | 71 in.*lbf | |
| Rear speed sensor wire harness clamp x Body | 8.0 | 82 | 71 in.*lbf | |
| Rear speed sensor wire harness clamp x Rear axle | 8.0 | 82 | 71 in.*lbf | |
| Yawrate sensor bracket x Body | 13 | 136 | 10 | |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
