2007 Toyota Prius BaseFACTORY OEM SERVICE PROCEDURE

Front Wheel Alignment: Adjustment

  1. INSPECT TIRE 
    1. Inspect the tires (see TIRE AND WHEEL SYSTEM ).
  2. MEASURE VEHICLE HEIGHT 

    Standard vehicle height 

    STANDARD VEHICLE HEIGHT CHART

    Item Specified Condition
    Front (A - B) 95 mm (3.74 in.)
    Rear (D - C) 62 mm (2.44 in.)

    Measuring points: 

    A : Ground clearance of front wheel center 

    B : Ground clearance of lower arm No. 1 set bolt center 

    C : Ground clearance of rear axle carrier bush set bolt center 

    D : Ground clearance of rear wheel center 

    NOTE: Before inspecting the wheel alignment, adjust the vehicle height to the specified value.

    HINT:

    Bounce the vehicle at the corners up and down to stabilize the suspension and inspect the vehicle height.

    Fig 1: Measuring Vehicle Height
    G04474384Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. INSPECT TOE-IN 

    Standard toe-in 

    STANDARD TOE-IN CHART

    Item Specified Condition
    Toe-in (total) A + B: 0° +-12' (0° +-0.2°)
    C - D: 0 +-2 mm (0 +-0.08 in.)

    HINT:

    • Measure "C - D" only when "A + B" cannot be measured.
    • If the toe-in is not within the specified range, adjust it at the rack ends.
      Fig 2: Measuring Toe-In
      G04474385Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. ADJUST TOE-IN 
    1. Measure the thread lengths of the right and left rack ends.

      Standard difference in thread length: 1.5 mm (0.059 in.) or less 

    2. Remove the rack boot set clips.
    3. Loosen the tie rod end lock nuts.
    4. Adjust the rack ends if the difference in thread length between the right and left rack ends is not within the specified range.
      1. Extend the shorter rack end if the measured toe-in deviates toward the outer-side.
      2. Shorten the longer rack end if the measured toe-in deviates toward the inner-side.
    5. Turn the right and left rack ends by an equal amount to adjust toe-in.

      HINT:

      Try to adjust toe-in to the center of the specified range.

    6. Make sure that the lengths of the right and left rack ends are the same.

      Standard : 0 +-1 mm (0.0039 in.) 

    7. Torque the tie rod end lock nuts.

      Torque: 74 N*m (755 kgf*cm, 55 ft.*lbf) 

      NOTE: Temporarily tighten the lock nut while holding the hexagonal part of the steering rack end so that the lock nut and the steering rack end do not turn together. Hold the width across the flat part of the tie rod end and tighten the lock nut.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.