Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Toyota Prius BaseFACTORY OEM SERVICE PROCEDURE
Service Data
SERVICE DATA REFERENCE
| STEERING WHEEL | |
| Steering effort (Reference) | 5.5 N*m (56 kgf*cm, 49 in.*lbf) |
| Steering wheel free play Maximum | 30 mm (1.18 in.) |
| POWER STEERING GEAR | |
| Tie rod end sub-assembly total preload (Turning) | 2.0 N*m (20.4 kgf*cm, 18 in.*lbf) or less |
| Steering gear assembly total preload (Turning) | 0.6 - 1.2 N*m (6.1 - 12.2 kgf*cm, 5 - 11 in.*lbf) |
| Steering rack boot clamp clearance | 3.0 mm (0.12 in.) or less |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
