2007 Toyota Prius BaseFACTORY OEM SERVICE PROCEDURE

Typical Enabling Conditions

Case 1 

TYPICAL ENABLING CONDITIONS - CASE 1

Monitor will run whenever these DTCs are not present P0100 - P0103 (MAF meter)
P0110 - P0113 (IAT sensor)
P0115 - P0118 (ECT sensor)
Engine coolant or intake air temperature at engine start -8.34°C (17°F)or more

Case 2 

TYPICAL ENABLING CONDITIONS - CASE 2

Monitor will run whenever these DTCs are not present P0100 - P0103 (MAF meter)
P0110 - P0113 (IAT sensor)
P0115 - P0118 (ECT sensor)
Engine coolant or intake air temperature at engine start Between -19.45°C (-3°F) and -8.34°C (17°F)

Case 3 

TYPICAL ENABLING CONDITIONS - CASE 3

Monitor will run whenever these DTCs are not present P0100 - P0103 (MAF meter)
P0110 - P0113 (IAT sensor)
P0115 - P0118 (ECT sensor)
Engine coolant or intake air temperature at engine start Lower than-19.45°C (-3°F)
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.