2007 Toyota Prius BaseFACTORY OEM SERVICE PROCEDURE

Power Window Regulator Motor: Inspection

  1. INSPECT POWER WINDOW REGULATOR MOTOR ASSEMBLY (for Front LH and Rear LH) 
    1. Apply battery voltage to connector terminals 1 and 2.
      NOTE: Do not apply battery voltage to any terminals except terminals 1 and 2.
    2. Check that the motor gear rotates smoothly as follows.

      OK 

      MEASUREMENT CONDITION AND SPECIFIED CONDITION

      Measurement Condition Specified Condition
      Battery positive (+) --> Terminal 2
      Battery negative (-) --> Terminal 1
      Motor gear rotates clockwise
      Battery positive (+) --> Terminal 1
      Battery negative (-) --> Terminal 2
      Motor gear rotates counterclockwise
      Fig 1: Inspecting Power Window Regulator Motor Assembly
      G04476776Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      If the result is not as specified, replace the regulator motor assembly.

  2. INSPECT POWER WINDOW REGULATOR MOTOR ASSEMBLY (for Front RH and Rear RH) 
    1. Apply battery voltage to connector terminals 1 and 2.
      NOTE: Do not apply battery voltage to any terminals except terminals 1 and 2.
    2. Check that the motor gear rotates smoothly as follows.

      OK 

      MEASUREMENT CONDITION AND SPECIFIED CONDITION

      Measurement Condition Specified Condition
      Battery positive (+) --> Terminal 1
      Battery negative (-) --> Terminal 2
      Motor gear rotates clockwise
      Battery positive (+) --> Terminal 2
      Battery negative (-) --> Terminal 1
      Motor gear rotates counterclockwise
      Fig 2: Inspecting Power Window Regulator Motor Assembly
      G04476777Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      If the result is not as specified, replace the regulator motor assembly.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.