Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Toyota Prius BaseFACTORY OEM SERVICE PROCEDURE
How To Proceed With Troubleshooting
HINT:
- Use these procedures to troubleshoot the electronically controlled brake system.
- *: Use the intelligent tester.
- VEHICLE BROUGHT TO WORKSHOPÂ
- CUSTOMER PROBLEM ANALYSISÂ
- CHECK DTC AND FREEZE FRAME DATA*Â
- CLEAR DTC AND FREEZE FRAME DATA*Â
- PROBLEM SYMPTOM CONFIRMATIONÂ
ResultÂ
SYMPTOM CHARTResult Proceed to Symptom does not occur A Symptom occur B B: Go to STEPÂ Â 7
A: Go to Next StepÂ
- SYMPTOM SIMULATIONÂ
- CHECK FOR DTC*Â
ResultÂ
SYMPTOM CHARTResult Proceed to There is no output A There is output B B: Go to STEPÂ Â 9
A: Go to Next StepÂ
- PROBLEM SYMPTOMS TABLEÂ
NEXT: CHECK FOR FLUID LEAKAGE AND GO TO STEPÂ Â 11
- SYMPTOM SIMULATIONÂ
- DTC CHARTÂ
- CIRCUIT INSPECTION*Â
- IDENTIFICATION OF PROBLEMÂ
- REPAIR OR REPLACEÂ
- CONFIRMATION TEST*Â
NEXT: ENDÂ
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
