Name: AllOEMManuals
Address: 316 Brandywine Ave, Streetman, TX, 75859, US
Telephone: +14699867883
Price range: $$

INSTALL THROTTLE BODY ASSEMBLY
1. Install a new gasket onto the intake manifold.
  
  Fig 1: Installing Gasket Onto Intake Manifold
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the throttle body with the 2 bolts and 2 nuts.
  Torque: 9.0 N*m (90 kgf*cm, 80 in.*lbf)
  
  Fig 2: Installing Throttle Body With Bolts And Nuts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Connect the water bypass hose No. 2 [C] to the throttle body.
4. Connect the water by pass hose [D] to the throttle body.
  
  Fig 3: Connecting Water Bypass Hose To Throttle Body
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. Connect the throttle control motor connector.
  
  Fig 4: Connecting Throttle Control Motor Connector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL AIR CLEANER CAP SUB-ASSEMBLY
1. Install the air cleaner cap together with the air cleaner hose.
  
  Fig 5: Installing Air Cleaner Cap Together With Air Cleaner Hose
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Tighten the hose clamp bolt, then connect the air cleaner hose.
  Torque: 2.0 N*m (20 kgf*cm, 18 in.*lbf)
  
  Fig 6: Tightening Hose Clamp Bolt And Air Cleaner Hose No. 1
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Connect the ventilation hose No. 1 to the cylinder head cover.
  
  Fig 7: Connecting Ventilation Hose No. 1 To Cylinder Head Cover
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Connect the fuel vapor feed hose No. 3 [D] to the VSV.
5. Connect the fuel vapor feed hose No. 1 [E] to the VSV.
  
  Fig 8: Connecting Fuel Vapor Feed Hose To VSV
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
6. Install the 2 wire harness clamps [F].
7. Connect the VSV connector [G].
8. Connect the mass air flow meter connector [H].
CONNECT BATTERY NEGATIVE TERMINAL
Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)
ADD ENGINE COOLANT (See COOLANT )
CHECK ENGINE COOLANT LEAK (See COOLING SYSTEM )
INSTALL CYLINDER HEAD COVER NO. 2
1. Install the cylinder head cover No. 2 with the 2 nuts and 2 clips.
  Torque: 7.0 N*m (71 kgf*cm, 62 in.*lbf)
  
  Fig 10: Installing Cylinder Head Cover No. 2
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply: