2007 Toyota Matrix Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Typical Enabling Conditions

Engine Coolant Temperature Sensor Output Stuck at Low Engine Coolant Temperature: 

TYPICAL ENABLING CONDITIONS

The monitor will run whenever the following DTCs are not present P0100, P0102, P0103 (MAF sensor)
Battery voltage 10.5 V
Time after engine start 1 second
ECT at engine start Less than 60°C (140°F)
IAT sensor circuit Not detected
Soak time 0 second
Accumulated MAF 712 g or more (A/T), 765 g or more (M/T)
Engine Running
Fuel cut OFF
Difference between ECT at engine start and IAT Less than 40°C (72°F)

Engine Coolant Temperature Sensor Output Stuck at High Engine Coolant Temperature: 

DIAGNOSTIC PROCEDURE

The monitor will run whenever the following DTCs are not present P0100, P0102, P0103 (MAF sensor)
Battery voltage 10.5 V
ECT at engine start 60°C (140°F) or more
Battery voltage 10.5 V or more
Engine Running
Soak time 18000 seconds
Accumulated MAF 765 g or more (A/T), 1220 g or more (M/T)

*1: Vehicle is stopped for 20 seconds or more and accelerated to more than 43.5 mph (70 km/h) within 40 seconds.

*2: Following these steps: 1) vehicle is driven at 40.4 mph (65 km/h) or more for 30 seconds or more and the vehicle speed reaches 43.5 mph (70 km/h); 2) vehicle is decelerated from 40.4 mph (65 km/h) to 1.86 mph (3 km/h) or less within 35 seconds; and 3) vehicle is stopped for 10 seconds.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.