Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Toyota Matrix Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Engine Control System (1ZZ-FE): ECM: Removal
- DISCONNECT BATTERY NEGATIVE TERMINAL
- REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY
- Remove the screw [A] from the glove compartment door stoppers.
- Deform the upper part of the glove compartment door assembly to release the stoppers [B].
- Pull the glove compartment door assembly upward to remove it.
- REMOVE ECM
- Remove the 2 clips using a clip remover, then open the cover.
- Disconnect the 4 ECM connectors [B].
- Remove the wire harness from the wire harness clamp [C].
- Remove the 2 screws [D].
- Unfasten the claw and clip, and then remove the ECM.
- REMOVE ECM COVER
- Remove the ECM cover from the ECM.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.
