Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Toyota Matrix Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Back Door Glass: Installation
- INSTALL BACK DOOR GLASS
Torque: 12 N*m (122 kgf*cm, 9 ft.*lbf)
- INSTALL BACK DOOR HINGE ASSEMBLY RH
- INSTALL BACK DOOR HINGE ASSEMBLY LH
- INSTALL BACK DOOR GLASS
- INSTALL WINDSHIELD WIPER MOTOR ASSEMBLY
- INSTALL RR WIPER MOTOR COVER
- INSTALL W/WASHER PACKING NUT REAR WIPER LINK PIVOT
- INSTALL REAR WIPER LINK CAP
- INSTALL REAR WIPER ARM ASSEMBLY
- INSTALL BACK DOOR PANEL SUB-ASSEMBLY UPPER OUTER
- If planning to reuse the back door panel upper outer: Clean the back door panel upper outer.
- Remove the adhesive tape from the back door panel upper outer.
- Wipe off the stains with cleaner.
- Apply new adhesive tape to the back door panel upper outer as shown in the illustration.
- Install the back door panel upper outer with the 4 screws and 4 nuts.
- If planning to reuse the back door panel upper outer: Clean the back door panel upper outer.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
