Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Toyota Land CruiserFACTORY OEM SERVICE PROCEDURE
Knock Sensor: Installation
- INSTALL KNOCK CONTROL SENSOR
- Install the 2 knock sensors with the 2 nuts, as shown in the illustration.
Torque: 20 N*m (204 kgf*cm, 15 ft.*lbf)
- Connect the 2 knock sensor connectors.
- Install the 2 knock sensors with the 2 nuts, as shown in the illustration.
- INSTALL AIR PUMP ASSEMBLY (See INSTALLATION )
- INSTALL INTAKE MANIFOLD ASSEMBLY (See LUBRICATION )
- CONNECT FUEL MAIN HOSE (See INSTALLATION )
- CONNECT FUEL RETURN HOSE (See INSTALLATION )
- INSTALL INTAKE AIR CONNECTOR PIPE (see INSTALLATION )
- INSTALL V-BANK COVER SUB-ASSEMBLY (see INSTALLATION )
- CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
- PERFORM INITIALIZATION NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
- ADD ENGINE COOLANT (See REPLACEMENT )
- CHECK FOR ENGINE COOLANT LEAKS
- Check for engine coolant leaks (see REPLACEMENT ).
- CHECK FOR FUEL LEAKS
- Check for fuel leaks (see ON-VEHICLE INSPECTION ).
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
