Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Toyota Land CruiserFACTORY OEM SERVICE PROCEDURE
Ignition System: Preparation: Suspension: SST
SUSPENSION SST TOOLS
| 09316-20011 | Transfer Bearing Replacer | - | |
| 09527-17011 | Rear Axle Shaft Bearing Remover | - | |
| 09628-62011 | Boll Joint Puller | - | |
| 09631-32020 | Seal Ring Tool | - | |
| 09710-14013 | Rear Suspension Bushing Tool Set | - | |
| (09710-00061) | Replacer | - | |
| 09710-22021 | Front Suspension Bushing Tool Set | - | |
| (09710-01071) | Lower Arm Bushing Remover | - | |
| 09710-28012 | Front Suspension Bushing Tool Set | - | |
| (09710-07031) | Bushing Replacer | - | |
| (09710-07062) | Bushing Replacer | - | |
| 09710-28021 | Front Suspension Bushing Tool Set | - | |
| (09710-08031) | Base | - | |
| 09710-30021 | Suspension Bushing Tool Set | - | |
| (09710-03101) | Bushing Replacer | - | |
| 09726-35011 | Front Lower Arm Bushing Remover & Replacer | - | |
| (09726-05021) | Gate | - | |
| 09726-36010 | Lower Control Arm Bushing Replacer | - | |
| 09830-36010 | Front Mounting Cushion Remover & Replacer | - | |
| 09950-00020 | Bearing Remover | - | |
| 09950-00030 | Bearing Remover Attachment | - | |
| 09950-40011 | Puller B Set | - | |
| (09957-04010) | Attachment | - | |
| 09950-70010 | Handle Set | - | |
| (09951-07100) | Handle 100 | - |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
