2007 Toyota Land CruiserFACTORY OEM SERVICE PROCEDURE

Throttle Body: Removal

  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
  2. DRAIN ENGINE COOLANT (See  REPLACEMENT  ) 
  3. REMOVE V-BANK COVER SUB-ASSEMBLY (see  REMOVAL  ) 
  4. REMOVE INTAKE AIR CONNECTOR PIPE (see  REMOVAL  ) 
  5. REMOVE THROTTLE BODY 
    1. Disconnect the throttle position sensor and control connector.
    2. Disconnect the 2 water bypass hoses.
      Fig 1: Locating Water By-Pass Hoses
      G05196929Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Remove the 3 bolts, nut, throttle body and gasket.
    Fig 2: Locating Bolts, Nut And Throttle Body
    G05196930Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.