Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Throttle Body: Installation
- INSTALL THROTTLE BODY
- Install a new gasket and the throttle body with the 3 bolts and nut.
Torque: 14 N*m (142 kgf*cm, 10 ft.*lbf)
- Connect the 2 water bypass hoses.
- Connect the throttle position sensor and control connector.
- Install a new gasket and the throttle body with the 3 bolts and nut.
- INSTALL INTAKE AIR CONNECTOR PIPE (see INSTALLATION )
- INSTALL V-BANK COVER SUB-ASSEMBLY (see CAMSHAFT POSITION SENSOR )
- CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
- PERFORM INITIALIZATION CAUTION: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
- ADD ENGINE COOLANT (See REPLACEMENT )
- CHECK FOR ENGINE COOLANT LEAKS
- Check for engine coolant leaks (see REPLACEMENT ).
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
No obligation. See pricing before you book.