Quick Lookups: Fluids

2007 Toyota Highlander Hybrid, FWDSECTION Fluids
FLUID CAPACITIES
Fluid Type Application Standard Metric Fluid Spec Note S/H
Air Cond Compressor Oil Gas/Electric 4.80 OZS. 0.14 L POE ND-OIL 11 Approximate capacity. S
Air Cond Refrigerant 1.30 LBS. 0.58 KG R-134a Approximate capacity. S
Automatic Transmission Fluid Hybrid,Hybrid Limited Front,w/o Towing Pkg 4.10 QTS. 3.88 L TOYOTA Genuine Automatic Transmission Fluid Type WS ATF JWS3324 or NWS9638. S
Automatic Transmission Fluid Hybrid,Hybrid Limited Front,w/Towing Pkg 4.40 QTS. 4.16 L TOYOTA Genuine Automatic Transmission Fluid Type WS ATF JWS3324 or NWS9638. S
Brake Fluid N/A N/A DOT 3 Brake Fluid S
Engine Coolant 3.3L Eng Inverter Coolant 3.60 QTS. 3.4 L TOYOTA Super Long Life Coolant or equivalent DO NOT use alcohol type antifreeze or plain water alone. S
Engine Coolant 3.3L Eng w/Heater 12.30 QTS. 11.64 L TOYOTA Super Long Life Coolant or equivalent DO NOT use alcohol type antifreeze or plain water alone. S
Engine Coolant 3.3L Eng w/o Rear Heater 10.90 QTS. 10.31 L TOYOTA Super Long Life Coolant or equivalent DO NOT use alcohol type antifreeze or plain water alone. S
Engine Oil 3.3L Eng Drain and Refill,w/Filter 5.00 QTS. 4.73 L ILSAC GF-4 SAE 5W-30 S
Engine Oil 3.3L Eng Drain and Refill,w/o Filter 4.80 QTS. 4.54 L ILSAC GF-4 SAE 5W-30 S
Fuel Tank 3.3L Eng 17.20 GALS. 65.1 L S
Power Steering Fluid N/A N/A Automatic Transmission Fluid DEXRON II or DEXRON III S
Windshield Washer Fluid N/A N/A Plain water In cold areas where temperatures range below the freezing point, use washer fluid containing antifreeze. Not radiator antifreeze. S
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.