2007 Toyota FJ Cruiser RWDFACTORY OEM SERVICE PROCEDURE

Throttle Body: Removal

  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
  2. DRAIN ENGINE COOLANT  (See REPLACEMENT )
  3. REMOVE V-BANK COVER 
    1. Remove the 2 nuts, then remove the V-bank cover.
      Fig 1: Identifying V-Bank Cover Nuts
      G05108981Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. REMOVE AIR CLEANER ASSEMBLY 
    1. Disconnect the No. 2 ventilation hose.
      Fig 2: Identifying No. 2 Ventilation Hose
      G04968651Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Disconnect the vacuum hose.
    3. Disconnect the mass air flow meter connector.
    4. Disengage the 2 wire harness clamps.
      Fig 3: Identifying Wire Harness Clamps
      G04968662Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    5. Loosen the 2 hose clamps.
    6. Remove the 2 bolts.
    7. Disconnect the air cleaner hose and remove the air cleaner.
      Fig 4: Identifying Hose Clamps
      G04968653Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  5. REMOVE THROTTLE WITH MOTOR BODY ASSEMBLY 
    1. Disconnect the No. 5 water bypass hose.
    2. Disconnect the No. 4 water bypass hose.
      Fig 5: Identifying Water Bypass Hoses
      G05108985Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Disconnect the throttle motor connector.
    4. Remove the 4 bolts, then remove the throttle w/ motor body and gasket.
      Fig 6: Identifying Throttle With Motor Body Bolts
      G04968658Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    5. Remove the No. 5 water bypass hose.
    6. Remove the No. 4 water by-passe hose.
      Fig 7: Identifying Water Bypass Hoses
      G05108987Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.