Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Toyota FJ Cruiser RWDFACTORY OEM SERVICE PROCEDURE
Camshaft Timing Oil Control Valve Assembly: Removal
- DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
- DRAIN ENGINE COOLANT (See REPLACEMENT )
- REMOVE V-BANK COVER (See REMOVAL )
- REMOVE AIR CLEANER ASSEMBLY (See REMOVAL )
- REMOVE THROTTLE BODY BRACKET (See REMOVAL )
- REMOVE OIL BAFFLE PLATE (See REMOVAL )
- REMOVE NO. 1 SURGE TANK STAY (See REMOVAL )
- REMOVE NO. 2 SURGE TANK STAY (See REMOVAL )
- REMOVE INTAKE AIR SURGE TANK (See REMOVAL )
- REMOVE CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY
- Disconnect the 2 connectors.
- Remove the 2 bolts, then remove the 2 camshaft timing oil control valves.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
