Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2007 Toyota FJ Cruiser 4WD, Part TimeFACTORY OEM SERVICE PROCEDURE

On-Vehicle Inspection

DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
REMOVE EFI RELAY
1. Remove the relay block cover upper.
2. Remove the EFI relay.
  
  Fig 1: Identifying Relay Block Cover Upper & EFI Relay
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

INSPECT EFI RELAY

Fig 2: Identifying EFI Relay

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Check the resistance.

Using an ohmmeter, measure the resistance between the terminals.

Standard resistance

STANDARD RESISTANCE SPECIFICATIONS

Tester Connection	Specified Condition
3 - 5	10 kΩ or higher
3 - 5	Below 1 Ω (Battery voltage applied to terminals 1 and 2)

If the result is not as specified, replace the EFI relay.

INSTALL EFI RELAY
1. Install the EFI relay.
2. Install the relay block cover upper.
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 3.9 N*m (40 kgf*cm, 35 in.*lbf)

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.