2007 Toyota Corolla LE, AutomaticFACTORY OEM SERVICE PROCEDURE

Throttle Body: Removal

  1. DISCONNECT BATTERY NEGATIVE TERMINAL 
  2. DRAIN ENGINE COOLANT  (See ON-VEHICLE INSPECTION )
  3. REMOVE CYLINDER HEAD COVER NO. 2 
    1. Remove the 2 nuts and 2 clips, then remove the cylinder head cover No. 2.
    Fig 1: Locating Cylinder Head Cover No. 2 Nuts And Clips
    G05192704Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
  4. REMOVE AIR CLEANER CAP SUB-ASSEMBLY 
    1. Disconnect the mass air flow meter connector [A].
    2. Disconnect the VSV connector [B].
    3. Remove the 2 wire harness clamps [C].
      Fig 2: Locating VSV And Mass Air Flow Meter Connectors
      G05192705Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
    4. Disconnect the fuel vapor feed hose No. 1 [D] from the VSV.
    5. Disconnect the fuel vapor feed hose No. 3 [E] from the VSV.
      Fig 3: Locating Fuel Vapor Feed Hose No. 1
      G05192706Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
    6. Disconnect the ventilation hose No. 1 from the cylinder head cover.
      Fig 4: Identifying Ventilation Hose No. 1
      G05192707Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
    7. Loosen the hose clamp bolt and air cleaner hose No. 1.
      Fig 5: Locating Hose Clamp Bolt
      G05192708Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
    8. Remove the air cleaner cap together with the air cleaner hose.
      Fig 6: Identifying Air Cleaner Hose
      G05192709Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
  5. REMOVE THROTTLE BODY ASSEMBLY 
    1. Disconnect the throttle control motor connector.
      Fig 7: Locating Throttle Control Motor Connector
      G05192710Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
    2. Disconnect the water bypass hose [B] from the throttle body.
    3. Disconnect the water bypass hose No. 2 [C] from the throttle body.
      Fig 8: Locating Water Bypass Hose
      G05192711Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
    4. Remove the 2 bolts and 2 nuts, then remove the throttle body.
      Fig 9: Locating Throttle Body Bolts And Nuts
      G05192712Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
    5. Remove the gasket from the intake manifold.
      Fig 10: Locating Intake Manifold Gasket
      G05192713Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.