Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Toyota Corolla CE, AutomaticFACTORY OEM SERVICE PROCEDURE
Accelerator Pedal: Inspection
- INSPECT ACCELERATOR PEDAL ASSEMBLY
- Check the resistance.
- Using an ohmmeter, measure the resistance between the terminals.
Standard resistance
TESTER CONNECTION SPECIFIED CONDITIONTester Connection Specified Condition 3 (EP1) - 6 (VCP1) 1.5 to 6.0 kΩ 1 (EP2) - 4 (VCP2) 1.5 to 6.0 kΩ If the result is not as specified, replace the accelerator pedal.
- Check the resistance.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.