Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2006 Toyota Sienna CEFACTORY OEM SERVICE PROCEDURE
Propeller Shaft: SST
PROPELLER SHAFT - SPECIAL SERVICE TOOL
| 09325-20010 | Transmission Oil Plug | |
| 09330-00021 | Companion Flange Holding Tool | |
| 09370-50010 | Drive Line Angle Gauge | |
| 09950-40011 | Puller B Set | |
| (09951-04020) | Hanger 200 | |
| (09952-04010) | Slide Arm | |
| (09953-04030) | Center Bolt 200 | |
| (09954-04010) | Arm 25 | |
| (09955-04061) | Claw No.6 | |
| (09957-04010) | Attachment | |
| (09958-04011) | Holder |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.