Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2006 Toyota Sienna CEFACTORY OEM SERVICE PROCEDURE

Drive Shaft: SST

DRIVE SHAFT - SPECIAL SERVICE TOOL

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002	09240-00020	Wire Gauge Set
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002	09520-01010	Drive Shaft Remover Attachment
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002	09520-24010	Differential Side Gear Shaft Puller
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002	(09520-32040)	Shocker Set
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002	09521-24010	Rear Axle Shaft Puller
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002	09527-10011	Rear Axle Shaft Bearing Remover
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002	09726-40010	Lower Control Shaft Bearing Replacer
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002	09930-00010	Drive Shaft Nut Chisel
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002	09950-00020	Bearing Remover

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.