Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2006 Toyota Sienna CEFACTORY OEM SERVICE PROCEDURE
Engine Control Systems: Preparation: Axle: SST
AXLE - SPECIAL SERVICE TOOL
| 09316-60011 | Transmission & Transfer Bearing Replacer | |
| (09316-00011) | Replacer Pipe | |
| (09316-00031) | Replacer B | |
| 09520-00031 | Rear Axle Shaft Puller | |
| 09527-17011 | Rear Axle Shaft Bearing Remover | |
| 09608-32010 | Steering Knuckle Oil Seal Replacer | |
| 09628-10011 | Ball Joint Puller | |
| 09628-62011 | Boll Joint Puller | |
| 09950-00020 | Bearing Remover | |
| 09950-60010 | Replacer Set | |
| (09951-00430) | Replacer 43 | |
| (09951-00600) | Replacer 60 | |
| 09950-60020 | Replacer Set No.2 | |
| (09951-00810) | Replacer 81 | |
| 09950-70010 | Handle Set | |
| (09951-07100) | Handle 100 |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.