WARNING: This page is about a different car, the 2006 Toyota Matrix. However, it is still accessible from the selected car via links, so may be relevant.

VEHICLE BROUGHT TO WORKSHOP
- GO TO NEXT STEP
CUSTOMER PROBLEM ANALYSIS
1. Interview and confirm the trouble.
  1. Confirm the condition of the trouble.
BASIC INSPECTION
1. Basic inspection.
  1. Check the battery voltage.
    Standard voltage: 11 to 14 V
2. Check the power supply to the radio receiver.
  1. Turn the ignition switch to the ACC position.
  2. Check whether or not the display appears on the radio receiver.
- DISPLAY DOES NOT APPEAR (PROCEED TO PROBLEM SYMPTOMS TABLE )
- DISPLAY APPEARS (GO TO STEP 4)
DTC CLEAR
Refer to DTC CHECK / CLEAR .
RECHECK DTC
Refer to DTC CHECK / CLEAR .
- DTC IS OUTPUT (GO TO STEP 6)
- DTC IS NOT OUTPUT (GO TO STEP 7 )
DTC CHART
Refer to DTC CHART .

NEXT: GO TO STEP 8
PROBLEM SYMPTOMS TABLE
Refer to PROBLEM SYMPTOMS TABLE .
CIRCUIT INSPECTION AND PART INSPECTION
- GO TO NEXT STEP
IDENTIFICATION OF PROBLEM
- GO TO NEXT STEP
CONFIRMATION TEST
- END

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.

• Brakes feel soft, pull hard to one side, or make grinding noises.

• The engine overheats, stalls repeatedly, or misfires under load.

• You are missing required tools, torque specs, or safe lifting equipment.

• You are not confident in the next step or safety outcome.

Safety Warning

How To Proceed With Troubleshooting

Use the Manual With the Right Hardware

When to See a Mechanic