Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Inspection Procedure
- PERFORM ACTIVE TEST BY INTELLIGENT TESTER (OPERATE CIRCUIT OPENING RELAY)Â
- Connect the intelligent tester to the DLC3.
- Turn the power switch ON (IG).
- Turn the tester ON.
- Enter the following menus: DIAGNOSIS / ENHANCED OBD II / ACTIVE TEST / FUEL PUMP / SPD.
- Check the relay operation while operating it with the tester.
OK : Operating noise can be heard from the relay.Â
OK : PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEMS TABLEÂ
NG : GO TO NEXT STEPÂ
- INSPECT POWER SOURCE CIRCUITÂ
NG : REPAIR OR REPLACE POWER SOURCE CIRCUIT COMPONENTSÂ
OK : GO TO NEXT STEPÂ
- INSPECT INTEGRATION RELAY (C/OPN RELAY)Â
- Remove the integration relay from the engine room relay block.
- Inspect the circuit opening relay.
Standard resistanceÂ
TESTER CONNECTION AND SPECIFIED CONDITIONTester Connection Specified Condition 3G-5 - 3G-8 10 kΩ or higher 3G-5 - 3G-8 Below 1 Ω
(Apply battery voltage to terminals 3G-6 and 3G-7) - Reinstall the integration relay.
NG : REPLACE INTEGRATION RELAYÂ
OK : GO TO NEXT STEPÂ
- CHECK ECM (FC VOLTAGE)Â
- Turn the power switch ON (IG).
- Measure the voltage between the specified terminals of the E5 and E6 ECM connectors.
Standard voltageÂ
TESTER CONNECTION AND SPECIFIED CONDITIONTester Connection Specified Condition E6-10 (FC) - E5-28 (E1) 9 to 14 V
GO : Go to step 5Â
NG : CHECK AND REPAIR HARNESS AND CONNECTORÂ
- INSPECT FUEL PUMPÂ
- Disconnect the F14 fuel pump connector.
- Inspect the fuel pump resistance.
- Inspect the fuel pump operation.
- Apply battery voltage to the fuel pump terminals. Check that the pump operates.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
