Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2006MATRIX BASE, FWD, STANDARDREPAIR AND DIAGNOSISRESTRAINTSRESTRAINTS CONTROL SYSTEMSPREPARATIONSUSPENSIONSST
2006 Toyota Matrix Base, FWD, Standard
Restraints Control Systems: Preparation: Suspension: SST
2006 Toyota Matrix Base, FWD, StandardSECTION SST
SUSPENSION SPECIAL SERVICE TOOL
| 09023-00101 | Union Nut Wrench 10 mm | |
| 09325-20010 | Transmission Oil Plug | |
| 09628-62011 | Boll Joint Puller | |
| 09632-36010 | Steering Vane Pump Bearing Replacer | |
| 09670-00010 | Front Crossmember Guide Tool | |
| 09703-30010 | Brake Shoe Return Spring Tool | |
| 09710-04101 | Base | |
| 09718-00010 | Shoe Hold Down Spring Driver | |
| 09727-30021 | Coil Spring Compressor | |
| 09729-22031 | Front Spring Upper Seat Holder | |
| 09930-00010 | Drive Shaft Nut Chisel | |
| 09950-40011 | Puller B Set | |
| (09951-04010) | Hanger 150 | |
| (09951-04020) | Hanger 200 | |
| (09952-04010) | Slide Arm | |
| (09953-04010) | Center Bolt 100 | |
| (09953-04030) | Center Bolt 200 | |
| (09954-04010) | Arm 25 | |
| (09954-04020) | Arm 100 | |
| (09955-04051) | Claw No.5 | |
| (09957-04010) | Attachment | |
| (09958-04011) | Holder | |
| 09950-60010 | Replacer Set | |
| (09951-00620) | Replacer 62 | |
| (09951-00630) | Replacer 63 |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.