Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2006MATRIX BASE, FWD, STANDARDREPAIR AND DIAGNOSISENGINE PERFORMANCESYSTEMENGINE CONTROL SYSTEM (1ZZ-FE) - SFI SYSTEM - COMPONENT TESTSCIRCUIT OPENING RELAYINSPECTION
2006 Toyota Matrix Base, FWD, Standard
Circuit Opening Relay: Inspection
2006 Toyota Matrix Base, FWD, StandardSECTION Inspection
- INSPECT E.F.I. CIRCUIT OPENING RELAY ASSEMBLY
- Inspect the resistance.
- Using an ohmmeter, measure the resistance between the terminals.
Resistance
TESTER CONNECTION - SPECIFIED CONDITIONSTester Connection Specified Condition 3 - 5 10 k or higher 3 - 5 Below 1 (Apply battery voltage to terminal 1 and 2) If the result is not as specified, replace the E.F.I. circuit opening relay assembly.
- Using an ohmmeter, measure the resistance between the terminals.
- Inspect the resistance.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.