Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2006MATRIX BASE, FWD, AUTOMATICREPAIR AND DIAGNOSISTRANSMISSIONAUTOMATIC TRANSPREPARATIONAXLESST
2006 Toyota Matrix Base, FWD, Automatic
Automatic Trans: Preparation: Axle: SST
2006 Toyota Matrix Base, FWD, AutomaticSECTION SST
AXLE SPECIAL SERVICE TOOL
| 09023-00101 | Union Nut Wrench 10 mm | |
| 09520-00031 | Rear Axle Shaft Puller | |
| 09527-17011 | Rear Axle Shaft Bearing Remover | |
| 09608-10010 | Steering Knuckle Oil Seal Replacer | |
| 09608-32010 | Steering Knuckle Oil Seal Replacer | |
| 09628-10011 | Ball Joint Puller | |
| 09628-62011 | Boll Joint Puller | |
| 09930-00010 | Drive Shaft Nut Chisel | |
| 09950-40011 | Puller B Set | |
| (09951-04020) | Hanger 200 | |
| (09952-04010) | Slide Arm | |
| (09953-04030) | Center Bolt 200 | |
| (09954-04010) | Arm 25 | |
| (09955-04061) | Claw No.6 | |
| (09957-04010) | Attachment | |
| (09958-04011) | Holder | |
| 09950-60010 | Replacer Set | |
| (09951-00370) | Replacer 37 | |
| (09951-00600) | Replacer 60 | |
| (09951-00640) | Replacer 64 | |
| 09950-60020 | Replacer Set No.2 | |
| (09951-00680) | Replacer 68 | |
| (09951-00720) | Replacer 72 | |
| 09950-70010 | Handle Set | |
| (09951-07100) | Handle 100 |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.