2006 Toyota Matrix Base, FWD, AutomaticFACTORY OEM SERVICE PROCEDURE

Power Window Regulator Motor: Inspection

  1. INSPECT POWER WINDOW REGULATOR MOTOR ASSEMBLY 
    1. Inspect the regulator motor operation.

      HINT:

      • The driver's side and rear RH regulator motors should be inspected in the same procedure.
      • The passenger's side and rear LH regulator motors should be inspected in the same procedure.
      1. Check that the motor operates smoothly when battery positive voltage is applied to each terminal of the connector.

        Standard: 

        Driver's side and rear RH side 

        MEASUREMENT CONNECTION AND SPECIFIED CONDITION REFERENCE (DRIVER'S SIDE AND REAR RH SIDE)

        Measurement Condition Specified Condition
        Battery positive (+) --> Terminal 4
        Battery negative (-) --> Terminal 5
        Clockwise toward driving axis
        Battery positive (+) --> Terminal 5
        Battery negative (-) --> Terminal 4
        Counterclockwise toward driving axis
        Fig 1: Inspecting Regulator Motor Operation
        G04466789Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

        Front passenger's side and rear LH side 

        MEASUREMENT CONNECTION AND SPECIFIED CONDITION REFERENCE (FRONT PASSENGER'S SIDE AND REAR LH SIDE)

        Measurement Condition Specified Condition
        Battery positive (+) --> Terminal 5
        Battery negative (-) --> Terminal 4
        Clockwise toward driving axis
        Battery positive (+) --> Terminal 4
        Battery negative (-) --> Terminal 5
        Counterclockwise toward driving axis

        If the result is not as specified, replace the motor.

    2. Inspect the PTC operation inside the regulator motor.
      NOTE: The inspection should be performed with the power window regulator and door glass installed to the vehicle.
      1. Set a DC 400 A probe of the TOYOTA electrical tester to terminal 4 or 5 of the wire harness.
        NOTE: Match the arrow mark of the probe with the current direction.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.