Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Back Window Lock: Inspection
- REMOVE BACK WINDOW LOCK ASSEMBLY
- Apply battery voltage and inspect the window lock motor operation, as shown in the illustration and table.
Standard voltage
MEASUREMENT CONNECTION AND SPECIFIED CONDITION REFERENCEMeasuring Condition Specified Condition Battery positive (+) --> Terminal 4
Battery negative (-) --> Terminal 3Open If the resistance as specified, replace the window lock assembly.
- Measure the resistance according to the value(s) in the table below.
Standard resistance
TERMINAL NO. AND SPECIFIED CONDITION REFERENCETerminal No. Door Lock latch Position Specified Condition 1 - 2 Open or half lock Below 1 Ω 1 - 2 Not pushed 10 kΩ or higher If the result is not as specified, replace the switch assembly.
- Apply battery voltage and inspect the window lock motor operation, as shown in the illustration and table.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
No obligation. See pricing before you book.