2006 Toyota Matrix Base, 4WDFACTORY OEM SERVICE PROCEDURE

Torque Specifications

TORQUE SPECIFICATIONS

Part Tightened N*m kgf*cm ft*lbf
Rear differential drain plug 39 398 29
Rear differential carrier cover plug (filler plug) 39 398 29
Rear differential filler plug (inspection plug) 98 1,000 72
Propeller w/ center bearing shaft assembly x Transmission coupling 74 750 54
Rear differential support No. 1 x Differential carrier assembly rear 103 1,050 76
Differential support x Differential carrier assembly rear 167 1,700 123
Rear differential support No. 1 x Rear suspension member 118 1,200 87
Differential support x Rear suspension member 137 1,400 101
Differential carrier cover x Differential carrier 20 200 14
Rear drive pinion nut 223 (245) 2,270 (2,500) 164 (181)
Side bearing retainer x Differential carrier 42 430 31
Side bearing retainer x Rear differential breather plug oil deflector 4.9 50 43 in.*lbf
Differential case x Differential ring gear 78 795 58

(): For use without SST

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.