Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2006 Toyota Highlander Limited, AWDFACTORY OEM SERVICE PROCEDURE
Preparation (Except Hybrid): Axle: SST
AXLE - SST CHART
| 09316-60011 | Transmission & Transfer Bearing Replacer | ||
| (09316-00011) | Replacer Pipe | ||
| (09316-00031) | Replacer B | ||
| 09520-00031 | Rear Axle Shaft Puller | ||
| 09527-17011 | Rear Axle Shaft Bearing Remover | ||
| 09608-32010 | Steering Knuckle Oil Seal Replacer | ||
| 09628-10011 | Ball Joint Puller | ||
| 09628-62011 | Boll Joint Puller | ||
| 09930-00010 | Drive Shaft Nut Chisel | ||
| 09950-00020 | Bearing Remover | ||
| 09950-60010 | Replacer Set | ||
| (09951-00430) | Replacer 43 | ||
| 09950-60020 | Replacer Set No.2 | ||
| (09951-00750) | Replacer 75 | ||
| (09951-00810) | Replacer 81 | ||
| 09950-70010 | Handle Set | ||
| (09951-07100) | Handle 100 |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
