Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2006 Toyota Camry Base, StandardFACTORY OEM SERVICE PROCEDURE

VVT Sensor (1MZ-FE/3MZ-FE): Replacement

HINT:

A bolt without torque specification is a standard bolt (see SPECIFIED TORQUE FOR STANDARD BOLTS ).

REMOVE AIR CLEANER INLET ASSY
REMOVE AIR CLEANER ASSY (See REPLACEMENT )
REMOVE VVT SENSOR
1. Disconnect the sensor connector.
2. Remove the bolt and sensor.
Fig 1: Removing VVT Sensor
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL VVT SENSOR
1. Apply a light coat of engine oil to the O-ring on the sensor.
2. Install the sensor with the bolt.
  Torque: 8.0 N.m (82 kgf.cm, 71 in.lbf)
3. Connect the sensor connector.
INSTALL AIR CLEANER ASSY (See REPLACEMENT )
INSTALL AIR CLEANER INLET ASSY
CHECK CONNECTION OF VACUUM HOSE

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.