Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Fuel Tank: Installation
- INSTALL FUEL TANK ASSEMBLY
- Install the 4 clip nuts.
- Install the 2 fuel tank bands with the 2 pins.
- Connect the fuel tank vent hose.
- Connect the fuel tank inlet pipe with the fuel filter pipe clamp.
- Tighten the 2 set bolts of the fuel tank bands.
Torque: 39 N m (400 kgf cm, 29 ft. lbf)
- Connect the fuel tube No.1.
- Push the fuel tube connector into the pipe until the fuel tube connector makes a "click" sound.
- Connect the fuel pump tube.
- Push in the fuel the connector to the pipe and push up the retainer so that the claws engage.
- INSTALL FUEL TANK PROTECTOR LOWER CENTER
- Install all fuel tank protector lower center.
Torque: 5.4 N m (55 kgf cm, 48 in. lbf)
- Install all fuel tank protector lower center.
- INSTALL PARKING BRAKE CABLE ASSEMBLY NO.3
- Install the parking brake cable assembly No.3 with the bolt and nut.
Torque: Bolt
6.0 N m (61 kgf cm, 53 in. lbf) Nut
8.5 N m (87 kgf cm, 75 in. lbf)
- Install the parking brake cable assembly No.3 with the bolt and nut.
- INSTALL PARKING BRAKE CABLE ASSEMBLY NO.2
- Install the parking brake cable assembly No.2 with the bolt and nut.
Torque: Bolt
6.0 N m (61 kgf cm, 53 in. lbf) Nut
8.5 N m (87 kgf cm, 75 in. lbf)
- Install the parking brake cable assembly No.2 with the bolt and nut.
- INSTALL EXHAUST PIPE ASSEMBLY CENTER (See INSTALLATION )
- INSTALL FUEL SUCTION TUBE ASSEMBLY WITH PUMP AND GAUGE (See step 1 under INSTALLATION )
- INSTALL FUEL TANK VENT TUBE SET PLATE (See step 2 under INSTALLATION )
- CONNECT FUEL PUMP TUBE SUB-ASSEMBLY (See step 3 under INSTALLATION )
- ADD FUEL
- CONNECT BATTERY NEGATIVE TERMINAL
- CHECK FOR FUEL LEAKS (See ON-VEHICLE INSPECTION )
- CHECK FOR EXHAUST GAS LEAKS
- INSTALL REAR FLOOR SERVICE HOLE COVER
- INSTALL REAR SEAT CUSHION ASSEMBLY
- PERFORM SYSTEM INITIALIZE
- Some systems need initialization when disconnecting the battery terminal.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
