Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Engine Coolant Temperature (ECT) Sensor: Inspection
- DRAIN ENGINE COOLANT
- REMOVE ECT SENSOR
- Disconnect the sensor connector.
- Using a 19 mm deep socket wrench, remove the sensor and gasket.
- INSPECT ECT SENSOR
Using an ohmmeter, measure the resistance between the terminals.
Resistance: Refer to the graph (See Fig 2)
If the resistance is not as specified, replace the sensor.
- REINSTALL ECT SENSOR
- Install a new gasket to the sensor.
- Using a 19 mm deep socket wrench, install the sensor.
Torque: 20 N.m (200 kgf.cm, 15 ft.lbf)
- Connect the sensor connector.
- REFILL WITH ENGINE COOLANT
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
No obligation. See pricing before you book.