2005 Toyota RAV4 Base, AWD, AutomaticFACTORY OEM SERVICE PROCEDURE

IGNITION RELAY (No.2) INSPECTION

  1. REMOVE IGNITION RELAY (Marking: IG2) 
    Fig 1: Removing Ignition Relay
    G02639615Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSPECT IGNITION RELAY 
    1. Check the resistance of the IG relay.

      Standard: 

      SPECIFIED CONDITION CHART

      Tester Condition Specified Condition
      3 - 5 10 kΩ or higher
      3 - 5 Below 1 Ω (when battery voltage is applied to terminals 1 and 2)

      If the result is not as specified, replace the relay.

  3. REINSTALL IGNITION RELAY 
    Fig 2: Checking Resistance Of IG Relay
    G02639616Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.