Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Circuit Description
With the smart key inside the luggage compartment, press the back door opener switch. The smart key ECU uses the back door oscillators (outer and inner) to output a request signal. The back door outer oscillator cannot verify an ID code in this situation. The smart key receives the request and transmits its ID code to the antenna. The ID code is then sent to the smart key ECU through the back door inner oscillator in order to be confirmed by the smart key ECU. If the ID code is verified, the smart key ECU sends a back door open signal to the instrument panel J/B (multiplex network body ECU) using the multiplex communication line and stops outputting request signals. The back door then can be opened.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
