2005 Toyota PriusFACTORY OEM SERVICE PROCEDURE

Inspection Procedure

  1. INSPECT FUSE (DOME) 
    1. Remove the DOME fuse from the engine room J/B and R/B.
    2. Measure the resistance of the fuses.

    Standard: Below 1 Ω 

    1. NG: REPLACE FUSE 
    2. OK: GO TO NEXT STEP 
  2. CHECK WIRE HARNESS (SMART KEY ECU ASSY - BATTERY AND BODY GROUND) 
    1. Disconnect the S11 ECU connector.
    2. Measure the voltage and resistance of the wire harness side connector.
      Fig 1: Checking Wire Harness (Smart Key ECU Assembly - Battery And Body Ground)
      G02617566Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Standard: 

      Fig 2: Tester Connection Specified Condition Chart
      G02617567Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. NG: REPAIR OR REPLACE HARNESS AND CONNECTOR 
    2. OK: GO TO NEXT STEP 

      REPLACE SMART KEY ECU ASSY 

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.