Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Smart Key Entry System (Keyless Entry) (Diagnostics): Registration
- DESCRIPTION OF REGISTRATION
HINT:
- Smart key codes are the same as recognition codes for the wireless transmitter. Registering a smart key code enables both the smart entry system and the wireless door lock control system to be operated.
- Code registration is necessary when the smart key ECU or smart key is replaced with a new one.
- Select the operation mode from the following:
- New registration mode (when smart key ECU is replaced):
Used when the smart key ECU is replaced with a new ECU.
- Add mode:
Used when a new key is added.
- Re-registration mode:
After using the erase mode to erase all smart key codes previously registered, use the re-registration mode to reenter them.
- Erasure mode:
Used to erase all the key codes except for the code of the master key that is used during erasure mode. Use this mode when a key is lost.
- Reset mode:
Used to reset all the key codes (including master key). Use this mode when all keys are lost.
- New registration mode (when smart key ECU is replaced):
- Perform the code registration and the code erasure according to the flowcharts (See STEP 2 and 3).
HINT:
Up to 5 master keys can be registered in the smart key ECU.
- Register a new key number or change the key number according to the flowcharts (See STEP 4 and 5). When the smart key ECU is replaced or all the key cylinders are replaced, be sure to register a new key number or change the key number in the smart key ECU.
HINT:
A key number is a 5-digit code stamped on the key number plate.
- REGISTRATION OF NEW AND ADDITIONAL SMART KEY CODE
- Register a smart key code using the hand-held tester.
HINT:
- A brief outline of procedures for key code registration is shown on this page and the previous page. For more detailed information, please refer to the hand-held tester screen's instructions.
- The number of currently registered codes can be checked on the first screen of the SMART CODE REG option.
- RE-REGISTRATION OF SMART KEY CODES AFTER ALL KEY CODES ERASED
- Re-register a smart key code using the hand-held tester.
HINT:
- A brief outline of procedures for key code registration is shown on this page and the previous page. For more detailed information, please refer to the hand-held tester screen's instructions.
- The number of currently registered codes can be checked on the first screen of the SMART CODE REG option.
- ERASURE OF SMART KEY CODE
- Erase the smart key codes using the hand-held tester.
HINT:
A brief outline of procedures for key code erasure is shown on this page. For more detailed information, please refer to the hand-held tester screen's instructions.
- RESET OF SMART KEY CODE
- Reset the smart key codes using the hand-held tester.
HINT:
- A brief outline of procedures for key code reset is shown on this page. For more detailed information, please refer to the hand-held tester screen's instructions.
- The SEED NUMBER is a 6-digit code.
- The PASS-CODE NUMBER is a 6-digit code.
- Reset mode will take approximately 16 minutes to complete.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
