2005 Toyota PriusFACTORY OEM SERVICE PROCEDURE

Smart Key Entry System (Keyless Entry) (Diagnostics): Inspection

  1. INSPECT SMART KEY CANCEL SWITCH ASSY 
    1. Measure the resistance of the switch.

      Standard: 

      TESTER CONNECTION SPECIFIED CONDITION

      Tester Connection Switch Condition Specified Condition
      1-2 Not pushed (OFF) 10 kΩ or higher
      1-2 Pushed (ON) Below 1Ω

      If the result is not as specified, replace the smart system cancel switch.

      Fig 1: Identifying Smart Key Cancel Switch Assembly
      G02617623Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSPECT BACK DOOR LOCK SWITCH 
    1. Measure the resistance of the switch.

      Standard: 

      TESTER CONNECTION SPECIFIED CONDITION

      Tester Connection Condition Specified Condition
      3-4 Not pushed (OFF) 10 kΩ or higher
      3-4 Pushed (ON) Below 1 Ω

      If the result is not as specified, replace the back door lock switch.

      Fig 2: Identifying Back Door Lock Switch
      G02617624Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. INSPECT ELECTRICAL KEY ANTENNA 
    1. Measure the resistance of the outside door handle.

      Standard: 

      TESTER CONNECTION SPECIFIED CONDITION

      Switch Condition Tester Connection Specified Condition
      Switch pushed 1-3 Below 1 Ω
      Switch not pushed 1-3 10 kΩ or higher

      If the result is not as specified, replace the outside door handle.

      Fig 3: Identifying Electrical Key Antenna
      G02617625Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. INSPECT ELECTRICAL KEY ANTENNA (REAR) 
    1. Measure the resistance of the antenna.

      Standard: 

      TESTER CONNECTION SPECIFIED CONDITION

      Tester Connection Condition Specified Condition
      1-2 Back door lock switch touched Below 1 Ω

      If the result is not as specified, replace the electrical key antenna (rear).

      Fig 4: Identifying Electrical Key Antenna (Rear)
      G02617626Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.