Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Inspection Procedure
- CHECK SMART DOOR LOCK AND UNLOCK OPERATION
- Check that the smart lock and unlock function operates normally.
OK: Smart lock and unlock function operates normally.
- NG: OTHER PROBLEM (See PROBLEM SYMPTOMS TABLE )
- OK: GO TO NEXT STEP
- Check that the smart lock and unlock function operates normally.
- READ DATA LIST (HALFWAY SWITCH)
- Connect the hand-held tester (with CAN VIM) to the DLC3.
- Turn the power switch from OFF to ON (IG) and press the hand-held tester main switch ON.
- Select the item below in the DATA LIST and read the displays on the hand-held tester.
Smart ECU:
OK: ON (key is in key slot) appears on the screen.
- NG: Go to PUSH BUTTON START SYSTEM (See HOW TO PROCEED WITH TROUBLESHOOTING )
- OK: GO TO NEXT STEP
- PERFORM ACTIVE TEST (INDOOR ELECTRICAL KEY OSCILLATOR)
- Connect the hand-held tester (with CAN VIM) to the DLC3.
- Turn the power switch from OFF to ON (IG) and press the hand-held tester main switch ON.
- Select the item below in the ACTIVE TEST and then check that the oscillator operates.
Smart ECU:
ACTIVE TEST (SMART ECU)Item Test Details Diagnostic Note FR TRANSMITTER Indoor electrical key oscillator ON/OFF OK: When smart key is brought close to indoor electrical key oscillator, oscillator is turned ON and indicator on smart key illuminates.
- Measure the frequency of the oscillator connector.
Standard:
TESTER CONNECTION SPECIFIED CONDITIONTester Connection Condition Specified Condition R8-3 (CLG) - R8-5 (GND) During ACTIVE TEST Some Hz
- NG: Go to STEP4
- OK: GO TO NEXT STEP
REPLACE SMART KEY ECU ASSY
- CHECK WIRE HARNESS (INDOOR ELECTRICAL KEY OSCILLATOR - SMART KEY ECU, BATTERY AND BODY GROUND)
- Disconnect the R8 oscillator connector.
- Disconnect the S11 ECU connector.
- Measure the voltage and resistance of the wire harness side connectors.
Standard:
TESTER CONNECTION SPECIFIED CONDITIONTester Connection Specified Condition R8-1 (B) - Body ground 10 to 14 V R8-5 (GND) - Body ground Below 1 Ω R8-3 (CLG) - S11-36 (CLG5) Below 1 Ω R8-3 (CLG) or S11-36 (CLG5) - Body ground 10 kΩ or higher
- NG: REPAIR OR REPLACE HARNESS AND CONNECTOR
- OK: GO TO NEXT STEP
REPLACE SMART KEY ECU ASSY
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
