Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Toyota PriusFACTORY OEM SERVICE PROCEDURE
Inspection Procedure
- RESET POWER WINDOW REGULATOR MOTOR FRONT LH (DRIVER SIDE)
- Reset the power window regulator motor (SEE INITIALIZATION ).
- Check if the power window AUTO UP/DOWN function operates normally.
OK: AUTO UP/DOWN function operates normally.
- NG: OTHER PROBLEM (SEE PROBLEM SYMPTOMS TABLE )
- OK
- CHECK JAM PROTECTION FUNCTION OPERATING RANGE
- Check that the jam protection function operates normally (SEE ON-VEHICLE INSPECTION
).
HINT:
The jam protection function does not operate from the fully closed position of the door glass to 4 mm (0.16 in.) below that.
OK: Jam protection function operates normally.
- NG: REPLACE POWER WINDOW REGULATOR MASTER SWITCH ASSY
- OK
END
- Check that the jam protection function operates normally (SEE ON-VEHICLE INSPECTION
).
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
