NOTE: The system will need to be initialized when tires are rotated, replaced with tires of different pressures, or tire pressure sensor and/or tire pressure monitor ECU are replaced.

Set tires to the specified (cold) pressures as indicated on the tire and loading information label.
Turn the engine switch ON.
Select SETTINGS DISPLAY (gear icon) on the multi-information display using the meter control switches on the steering wheel. See Fig 1.
Select VEHICLE INFORMATION and then press and hold OK.
Select TPWS and then press OK.
Select SET PRESSURE then press and hold OK until the tire pressure warning light blinks 3 times.
NOTE: A message will then be displayed on the multi-information display. "---" will be displayed on the multi-information display for the inflation pressure of each tire while initialization is being performed.
Drive straight (with occasional left and right turns) at approximately 25 mph (40 km/h) or more for approximately 10 to 30 minutes.
Initialization is complete when the position of each tire is determined and the inflation pressure of each tire is displayed on the multi-information display.
NOTE: Initialization may take longer than approximately 1 hour in certain situations, such as when the vehicle is stopped for a long time at traffic lights, etc.

Fig 1: Operating Meter Control Switches on Steering Wheel

Courtesy of TOYOTA

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.

• Brakes feel soft, pull hard to one side, or make grinding noises.

• The engine overheats, stalls repeatedly, or misfires under load.

• You are missing required tools, torque specs, or safe lifting equipment.

• You are not confident in the next step or safety outcome.

Safety Warning

TPMS Reminder Reset - Procedure 19: Initialization

Use the Manual With the Right Hardware

When to See a Mechanic

Rather have a pro handle this?