SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2005MATRIX XR, FWD, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEWINDOWSWINDSHIELD/WINDOWGLASS/MIRRORWINDOW DEFOGGER SYSTEMINSPECTION
2005 Toyota Matrix XR, FWD, Standard

Window Defogger System: Inspection

2005 Toyota Matrix XR, FWD, StandardSECTION Inspection
  1. INSPECT REAR WINDOW DEFOGGER SWITCH ASSY 
    1. Inspect the defogger switch.
      1. Connect the battery's positive (+) lead to terminal 2 and negative (-) lead to terminal 3. Check that the indicator lamp turns on.
        2. Fig 1: Connecting Battery's Positive (+) Lead To Terminal 2 And Negative (-) Lead To Terminal 3 (Checking Indicator Lamp Turns On)
        G02635655Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      If the result is not as specified, replace the switch or bulb.

    2. Inspect the defogger timer operation.
      1. Connect the battery's positive (+) lead to terminal 2 and negative (-) lead to terminal 3.
        2. Fig 2: Connecting Battery's Positive (+) Lead To Terminal 2 And Negative (-) Lead To Terminal 3
        G02635656Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      2. Connect the battery's positive (+) lead to terminal 6 through a 1.4 W test bulb.
      3. Turn the defogger switch ON. Check that:
        • The indicator lamp in the switch and test bulb turn on.
        • After approximately 12 to 18 minutes, the indicator lamp and test bulb turn off.

      If the result is not as specified, replace the switch.

  2. INSPECT DEFOGGER RELAY (Marking: DEFOG) 
    1. Remove the DEFOG relay from the instrument panel J/B.
    2. Measure the resistance of the relay.
      TERMINAL NO SPECIFIED CONDITION

      Terminal No. Specified Condition
      3-5 10kΩ or higher
      3-5 Below 1 Ω (when battery voltage is applied to terminal 1 and 2)

      If the result is not as specified, replace the relay.

      Fig 3: Measuring Resistance Of Relay
      G02635657Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.