2005 Toyota Matrix Base, FWD, StandardFACTORY OEM SERVICE PROCEDURE

Service Data

1ZZ-FE: 

Service Specifications - Lubrication (1ZZ-FE)

Oil pressure at idle speed 29 kPa (0.3 kgf.cm2 , 4.3 psi) or more
at 3, 000 rpm 294 to 539 kPa (3.0 to 5.5 kgf cm2 , 43 to 78 psi)
Oil pump assy  
Tip clearance Standard 0.040 to 0.160 mm (0.0016 to 0.0063 in.)
Maximum 0.160 mm (0.0063 in.)
Side clearance Standard 0.025 to 0.071 mm (0.0010 to 0.0028 in.)
Maximum 0.071 mm (0.0028 in.)
Body clearance Standard 0.260 to 0.325 mm (0.0102 to 0.0128 in.)
Maximum 0.325 mm (0.0128 in.)

2ZZ-GE: 

Service Specifications - Lubrication (2ZZ-GE)

Oil pressure at idle speed 39.2 kPa (0.4 kgf cm2 , 5.7 psi) or more
at 3, 000 rpm 294 to 539 kPa (3.0 to 5.5 kgf.cm2 , 43 to 78 psi)
Oil pump assy  
Tip clearance Standard 0.060 to 0.180 mm (0.0024 to 0.0071 in.)
Maximum 0.35 mm (0.0138 in.)
Body clearance Standard 0.125 to 0.180 mm (0.0049 to 0.0071 in.)
Maximum 0.325 mm (0.0128 in.)
Side clearance Standard 0.030 to 0.080 mm (0.0012 to 0.0032 in,)
Maximum 0.16 mm (0.0063 in.)
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.