2005 Toyota Matrix Base, 4WDFACTORY OEM SERVICE PROCEDURE

Torque Specifications

TIGHTENING TORQUE SPECIFICATIONS - TRANSFER

Part Tightened N.m kgf.cm ft.lbf
Driven pinion gear nut (w/SST) 260 to 355 2,647 to 3,616 191 to 262
Ring gear at Transfer ring gear mounting case 78 790 57
Bearing cap set bolt 63 644 47
Transfer extension housing sub-assy at Transfer case 26 260 19
Transfer extension housing sub-assy at Transfer dynamic damper 26 260 19
Breather oil deflector set bolt 6.5 66 58 in.lbf
Transfer case rear cover No.1 at Transfer case 19 200 14
Transfer drain plug at Transfer assy 49 500 36
Transfer case No.1 plug at Transfer assy 49 500 36
Transfer case No.2 plug at Transfer assy 49 500 36
Transfer & transaxle setting stud bolt at Transfer assy 39 400 29
Transfer assy set nut 69 700 51
Transfer assy at Transfer stiffener plate center 34 347 25
Transfer assy at Engine mounting bracket RR 64 652 47
Transfer assy at Transfer stiffener plate RH 34 347 47
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.