2005 Toyota Matrix Base, 4WDFACTORY OEM SERVICE PROCEDURE

Torque Specifications

1ZZ-FE: 

TIGHTENING TORQUE SPECIFICATIONS - LUBRICATION (1ZZ-FE)

Part Tightened N.m kgf.cm ft.lbf
Oil pressure switch at Crankshaft bearing cap sub-assy 15 153 11
Oil pump assy at Cylinder block sub-assy 9.0 92 80 in.lbf
Chain vibration damper No. 1 at Cylinder head sub-assy 9.0 92 80 in.lbf
Chain vibration damper No. 1 at Cylinder block sub-assy 9.0 92 80 in.lbf
Battery negative terminal at Battery 5.4 55 48 in.lbf
Front wheel RH at Front axle hub sub-assy RH 103 1,050 76
Oil pump relief valve plug at Oil pump body 37 377 27
Oil pump cover at Oil pump body 10 102 7
Oil pan drain plug at Oil pan sub-assy 37 377 27
Oil filter sub-assy at Oil filter union 13 133 10

2ZZ-GE: 

TIGHTENING TORQUE SPECIFICATIONS - LUBRICATION (2ZZ-GE)

Part Tightened N.m kgf.cm ft.lbf
Oil pressure switch at Crankshaft bearing cap sub-assy 15 153 11
Oil pump assy at Cylinder block sub-assy 9.0 92 80 in.lbf
Oil pan drain plug at Oil pan sub-assy 37 377 27
Oil pump cover at Oil pump body 10 105 8
Oil pump relief valve plug at Oil pump body 49 500 36
Oil filter sub-assy at Oil filter union 13 133 10
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.