Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Toyota Matrix Base, 4WDFACTORY OEM SERVICE PROCEDURE
Service Data
Service Specifications - Cooling
| Thermostat | ||
| Valve opening temperature | 80 to 84°C (176 to 183°F) | |
| Valve lift | at 95°C (203°F) | 10 mm {0.39 in.) or more |
| Radiator cap sub-assy | ||
| Standard opening pressure | 74 to 103 kPa (0.75 to 1.05 kgf/cm2 , 10.7 to 14.9 psi) | |
| Minimum opening pressure | 59 kPa (0.6 kgf/cm2 , 8.6 psi) | |
| Cooling fan | ||
| Standard amperage | at 20°C (68°F) | |
| 1ZZ-FE | 7.9 to 10.9 A | |
| Cooling fan relay | ||
| Resistance | 3 - 5 | 10 kΩ or higher |
| 3-5 (Apply battery voltage to terminals 1 and 2) | Below 1 Ω | |
| Cooling fan relay No. 2 | ||
| Resistance | 3 - 4 | Below 1 Ω |
| 3 - 4 (Apply battery voltage to terminals 1 and 2) | 10 kΩ or higher | |
| 3 - 5 | 10kΩ or higher | |
| 3 - 5 (Apply battery voltage to terminals 1 and 2) | Below 1 Ω | |
| Cooling fan | ||
| Resistance | at 20°C (68°F) | 1.17 to 1.43 Ω |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.